Materials Needed
- 1/16 in. PreciseBIT Non-Ferrous Cutter (Part
Number
MN208-0625-013F)
- 8 x16 in.
- Acetone
- Superglue
- Backing Material
- Newspaper sheet
- 3/4 in. MDF Board
Cutting letters from a single
brass sheet
- Clean Brass Sheet with Acetone
- Spread Superglue on Copper Sheet
- Place 3/4 in. MDF board on top of newspaper
sheet
- Press Brass Sheet down on 3/4 in. MDF board
and press to
flatten the Brass Sheet
- Wait approximately five minutes
- Complete Cuts
- Pour Acetone Between Brass Sheet and Backing
material to separate them
To Cut Multiple Brass Sheet Layers
Have you ever needed to cut out several of the
same letters at the same time?
Try this technique out. You can cut
up to four Copper Sheets out with one of our 1/16 in. cutters.
- Complete Steps 1-3 as described above
- Spread Superglue on Brass Sheet #2 place on
top of Brass Sheet #1
- Repeat Step 2 until a total of four Brass Sheets have been added
- Complete Cuts
- Pour Acetone between Brass Sheet(s) and
Backing material to separate them
Notes
You may use both sides of your backing material before you discard.
|
